Square Edge White Sparkle Kitchen Worktop 40mm x 1000mm x 600

£59.99

Share:

Square Edge White Sparkle 40mm x 1m x 600mm

This square edge white sparkle 40mm x 1m brings a bright white with sparkle flecks finish to the kitchen in a 1000mm x 600mm piece, 40mm thick. The front edge has a crisp, square profile, as the profile drawing in the photos shows, for a clean, modern line along the front of the units.

White Sparkle is a bright white worktop scattered with fine silver and grey flecks that catch the light, giving the clean look of white quartz with a little glitter. It makes a small kitchen feel larger and lighter, and it suits grey, navy, black and white units alike, especially with chrome or stainless steel taps and handles.

Square Edge White Sparkle 40mm x 1m, view 1

Key features of the square edge white sparkle 40mm x 1m

  • Colour: White Sparkle, bright white with sparkle flecks
  • Thickness: 40mm
  • Length: 1000mm (1m)
  • Depth: 600mm
  • Edge: square, modern square edge profile
  • Use: kitchen and utility room worktops
  • Quantity: 1 piece

Square Edge White Sparkle 40mm x 1m, view 2

The White Sparkle finish

Before ordering, compare the colour photos with your cabinet doors and floor in natural daylight: worktops look different under warm artificial light. The square edge white sparkle 40mm x 1m pattern runs along the length of the piece, so plan any joints and cut-outs where the pattern will line up neatly.

Square Edge White Sparkle 40mm x 1m, view 3

Choosing the length

A 1000mm (1 metre) length suits a short run over a single base unit, a section beside a cooker or fridge, a utility room, or the end of a kitchen island. It is also handy as a replacement piece when only one part of a kitchen needs a new top. At 40mm thick and 600mm deep, it suits standard base units.

Measure each run from the wall to the end of the last unit, add a little extra for trimming, and decide where any joints will fall, ideally away from the sink.

Square Edge White Sparkle 40mm x 1m, view 4

Cutting and fitting

Dry-fit the square edge white sparkle 40mm x 1m on the units before fixing anything. Mark cuts carefully, protect the cutting line with masking tape and cut from the decorative face with a fine-toothed blade so the edge stays clean. Support both sides of the cut so the piece does not drop or chip at the end of the cut.

Fix worktops to the base units from underneath with brackets or screws that are shorter than the worktop is thick, and check everything is level along the run before fixing.

Square Edge White Sparkle 40mm x 1m, view 5

Sealing edges and cut-outs

Water getting into cut edges and joints is the most common cause of worktop damage, so seal every cut edge, joint and sink or hob cut-out with a suitable sealant before fitting, following the instructions supplied with your sealant. Finish the back edge against the wall with an upstand or a bead of silicone, and use matching edging strips on exposed ends. Browse our upstands and edging strips to finish the job.

Everyday care

Wipe the surface with a soft cloth and warm water with a little mild detergent, then dry it. Mop up spills straight away, especially around the sink and along joints. Avoid scouring pads, abrasive creams and harsh solvents, which can dull the finish.

Always use a chopping board for knives and a trivet or pan stand under hot pans, kettles and slow cookers rather than putting them straight onto the surface. Browse our chopping boards for a matching set.

Joining two lengths

Where two worktops meet in a corner or along a long run, the joint needs to be tight and sealed. Many fitters use a worktop joint strip, which covers the cut ends neatly, or a mason’s mitre cut with a jig for a seamless look. Whichever you choose, seal the joint before the pieces are pulled together, wipe away any excess straight away, and plan joints away from the sink where water collects. A single long piece of square edge white sparkle 40mm x 1m avoids joints altogether on a straight run.

Sink and hob cut-outs

Use the template supplied with your sink or hob to mark the cut-out, drill a starting hole in each corner and cut with a jigsaw fitted with a fine blade, supporting the waste piece so it does not break away and chip the surface. Seal the raw edges of the cut-out thoroughly before fitting the sink or hob, and use the seal supplied with the appliance. Leave the gap around a hob that the hob maker recommends.

30mm or 40mm thick?

Worktop thickness changes the look of a kitchen. A 40mm edge has a classic, chunky presence that suits traditional and shaker kitchens, while a 30mm edge looks slimmer and more contemporary. The square edge white sparkle 40mm x 1m is 40mm thick; keep the same thickness across a kitchen so joints and upstands line up.

Planning a kitchen refresh

Changing the worktops is one of the quickest ways to transform a kitchen without replacing the units. Pair a new bright white with sparkle flecks surface with fresh handles, a new sink or tap and matching upstands, and the whole room looks updated. Order all lengths in one go so every piece of the square edge white sparkle 40mm x 1m range comes from the same batch and matches.

At a glance

  • Square Edge White Sparkle 40mm x 1m
  • bright white with sparkle flecks finish
  • 40mm thick, 600mm deep
  • Square front edge
  • Fits standard base units
  • Seal all cut edges when fitting

Square Edge White Sparkle 40mm x 1m questions

What size is it? 40mm thick, 1000mm long and 600mm deep.

What does the edge look like? A crisp, square front edge, as shown in the profile photo.

Can I cut it to size? Yes. Cut it with a fine-toothed blade from the decorative face, and seal the cut edges before fitting.

Do I need to seal it? Seal every cut edge, joint and cut-out so water cannot get in.

Can I put hot pans on it? Use a trivet or pan stand for hot pans, kettles and slow cookers.

How do I clean the square edge white sparkle 40mm x 1m? Wipe with a soft cloth and warm, mildly soapy water, then dry. Avoid abrasive cleaners.

What finishes the back edge? An upstand or a bead of silicone against the wall, with edging strips on exposed ends.

Looking for more like this worktop? Browse the full Worktops collection or the rest of the Kitchen Worktops shop. To learn more, see this overview of countertops.

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.